Installing a well pump can sound deceptively simple. You just need to drop it in, hook it up, and voila, instant water… right? Well, not exactly. There are several subtle nuances and critical details that can make the difference between a well-functioning pump and a costly, watery disaster.
In this article, we’d like to go over a couple common mistakes to avoid while installing a well pump. Here are four things you shouldn’t do during this process:
- Ignore the site assessment. Before you even think about installing a well pump, conducting a thorough site assessment is crucial. This involves evaluating the depth of your well, its yield, the water table level, and the electrical requirements of your pump.
- Improperly place the pump. Once you’ve selected the right pump for your well, you must properly place and support it. This means setting the pump at the appropriate depth, securing it to prevent movement, and properly aligning the pipes. Placing it too high can lead to cavitation, whereas placing it too low might cause the pump to suck up sediment and debris.
- Not following electrical codes. From using the wrong wire size to failing to properly ground the pump, electrical mistakes can lead to reduced pump performance, frequent breakdowns, and even electrical hazards. To avoid these issues, it’s essential to follow all manufacturer guidelines and local electrical codes when wiring your pump.
- Choose the wrong pump size. Installing a well pump that’s too small will make it less likely to keep up with your water demands, while one that’s too large will waste energy and create premature wear and tear.
If you need professional help installing a well pump, give us a call today.
